Kitchen advice for Dudley homes
Fitting a kitchen yourself: how hard is it really?
Some people can fit a kitchen themselves. Many start and call a fitter halfway. This page sorts the jobs into the ones most people can do and the ones that need a tradesperson.
Tasks within reach of a keen DIYer
Putting together flat-pack units, fitting handles and hanging doors are tasks many people do. They need patience, a spirit level and a drill. The door guide says doing the fitting yourself can save up to around £250 on a door swap.
- Building flat-pack carcasses
- Fixing handles
- Hanging doors
- Fitting plinths
- Painting
The jobs that are hard
Some jobs punish a mistake.
- Cutting and joining worktops, since a bad cut cannot be undone
- Levelling base units on an uneven floor
- Fitting wall units on a wall that is not straight
- Moving pipes
- Anything involving gas or electricity
Leave gas and electrical work to someone with the right qualifications.
What it costs you
Fitting labour on a standard kitchen is given as £1,700 to £3,000 in the kitchen fitting guide, or about 30 per cent of the cost. That sum is what doing it yourself could save. You also take on the risk of spoiled worktops, the cost of tools and the time.
A middle route
Many people do the stripping out and the painting, and hire a fitter for the middle. That keeps the skilled part with someone who does it every week and cuts the labour bill.
How long it takes
A fitter gives about three days of labour for a small kitchen and five for a large one. A first-timer working at weekends may need several weeks, with no kitchen for all of that time.
Tools you will need
A kitchen needs more than a drill. A spirit level, a long straight edge, a stud finder, a jigsaw or router for the worktop, clamps, a hole saw for pipes and a good set of drill bits are all in use.
- Spirit level and straight edge
- Drill and a full set of bits
- Jigsaw or router for worktops
- Clamps and a tape measure
- A hole saw for pipes and cables
A sensible order if you go ahead
Fit wall units first, so you are not leaning across base units. Then fit base units, then the worktop, then the sink. Doors and handles go on last so they do not get knocked.
When to stop and call someone
If a wall is not flat, a pipe is in the way or a worktop joint will not close, stop. A fitter can take over from that point. It costs less than a ruined worktop.
The cost of getting it wrong
A cut worktop cannot be put back together. A guide gives worktop replacement at an average of about £600, and laminate to stone ranges from £200 to £4,200 for a five metre run. A wrongly cut sink hole means buying the whole run again. Many people pay a fitter for the worktop alone.
Common questions
Can I fit a kitchen myself with no experience?
You can try, but the worktop is the risk. Many first-timers do everything but the worktop and the plumbing.
Which part of a kitchen is hardest to fit yourself?
The worktop. A bad cut cannot be undone, and joints need to be sealed well.
Not sure how much to take on?
A fitter can quote for just the parts you do not want to do, so you control the cost. Putting off the decision tends to leave you in a half-finished kitchen.
Say which jobs you want help with and where in Dudley you live. Asking is free.